![]() This list is ideally defined in a template, representing the list of scales we might need to plot from the plotting space layout.Ĭhanging the scale adjusts the ratio of drawn to plotted units and after performing a screen regen the linetypes should usually appear as expected. The modern method of controlling AutoCAD linetypes is via the annotative scale list at the bottom of the screen. Once this has been established we can set our drawing to plotting ratios, also referred as the plot scale. This is achieved by measuring something that is known, a wall width, length or similar and then check the drawing units. The first thing to look at is to verify that the drawing has been drawn at 1:1 and establish what units have been used. This blog will hopefully shed light on the things we need to check and adjust in AutoCAD to obtain a successful outcome. Sometimes, problems occur where lines should show as patterned, but stubbornly refuse all attempts to display correctly, both on screen and when plotting. Whilst we may draw at 1:1, annotation such as text and line patterns are for visual purposes only and need to be scaled up for larger drawing productions such as site plans and buildings. This is often due to insufficient training, or the challenges faced when receiving poorly configured or produced drawings from third parties. ![]() ![]() Linetypes seem to be the bane of many AutoCAD users. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |